mirror of
https://github.com/andreili/klipper.git
synced 2025-08-24 03:44:06 +02:00
bec1d957d2
On a USB bus reset the controller address needs to be reset to zero. Otherwise, the device becomes unresponsive after a USB reset and will remain unresponsive until a power cycle. This often shows up in the Linux system logs as "device descriptor read/64, error -32" messages. Make sure USB_INTE_BUS_RESET_BITS is enabled and clear the USB address on a bus reset. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.