Support setting individual options instead of one global option (
WANT_BUTTONS, WANT_TMCUART, WANT_NEOPIXEL, WANT_PULSE_COUNTER,
WANT_HX71X).
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This option seems to be confusing ld's region usage checks (builds
that could fit in small chips are being reported as not fitting). The
option was disabled back in commit 4e8674d5 because it showed worse
results. However, recent versions of gcc seem to produce the same
results even if this option is enabled, so change the build to avoid
disabling that option on newer versions of gcc (those that have the
-ffat-lto-objects option - which is needed to ensure
compile_time_requests sections can be extracted with objcopy).
The PRU build is dependent on -fuse-linker-plugin, so enable that
option explicitly in its build.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Don't build the pru binaries directly in the build test cases, instead
use the upstream binaries provided.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Commit 70838797 added support for clearing the homing state in
SET_KINEMATIC_POSITION commands. However, it can be difficult to use
that support as the default for SET_KINEMATIC_POSITION is to set all
axes as homed.
Add a new SET_HOMED parameter to allow one to explicitly request which
axes to consider in a homed state.
Also introduce a CLEAR_HOMED parameter and prefer that to the existing
CLEAR parameter.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The i2c_delay() function did not properly handle counter rollovers.
It also performed an expensive run-time divide.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
A security vulnerability was found in Jinja 3.1.5 . The software is
not impacted by this vulnerability, but there is no harm in updating
to the fixed version.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
The output_pin template code has a cache to speed up duplicate
rendering of templates. However, this cache doesn't work if one of
the parameters is a Python list or dictionary. Just disable the cache
in this case.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
It seems both ERRIE and LECIE must be enabled to get hardware error
interrupts. Without this, the rx_error and tx_error reports are
likely to always be zero.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
You can use the 40Mhz crystal oscillator recommended by TI official manual to get the best performance.
refer to: [ldc1612.pdf](https://www.ti.com/cn/lit/ds/symlink/ldc1612.pdf) 7.3.4
Signed-off-by: Xiaokui Zhao <xiaok@zxkxzk.cn>
Add a new "low level option" to allow users to configure if they want
to optimize for Trinamic drivers or traditional stepper motor drivers.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Add support for "step on both edges" to the main stepper_event_full()
code. This makes that mode of operation available even when the
micro-controller is not compiled for "optimized step on both edges".
It also enables the custom pulse duration support (step_pulse_ticks)
when in "step on both edges" mode.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
